NEWS‎ > ‎

Pop Goes the Bezel!

posted Feb 9, 2017, 10:39 PM by Richard Glueck   [ updated Feb 9, 2017, 10:41 PM ]
PERC finished machining the replacement tender backup light bezel ring, cast by Peter Grant. While it should have matched up exactly, they found it necessary to pull out the original brass pins and replace them with bolts, which isn't historical, but the ring fits very well. We need to get or fabricate tabs to hold in the headlight glass, then Peter will cast a replacement latch handle and service door. This should be done in the next week or two.

To recap: The can body of the backup lamp was restored by Forrest Autobody of Winterport. Casting pattern was made by Bernie Perch of Minersville, Penn., using the remaining 4 inch fragment of the original bezel. Odd Duck Foundry of Orrington, cast the iron bezel ring with about five attempts that failed, but from which he perfected a technique. We got one! Penobscot Energy Recovery Corporation (PERC) also in Orrington, milled the bezel so it fits the can body.